Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE Installationsanleitung

HP System Management HomepageInstallation GuideHP-UX, Linux and Windows SystemsHP Part Number: 438862-007Published: December 2007Edition: 14

10

2 Installation requirementsThis chapter provides requirements for the HP-UX, Linux, and Windows systems to run HPSystem Management Homepage (HP SMH):•

• SUSE Linux Enterprise Server 9 for AMD64 and Intel EM64T, Service Pack 4• SUSE Linux Enterprise Server 9 for Itanium Linux, Service Pack 4• SUSE Lin

NOTE: Installation of HP SMH does not require a browser.The HP Web-enabled System Management Software is hardware-dependent. For the installationto co

RPMs supported on the Itanium platformHP SMH supports the following RPMs for each of the Linux operating systems on the Itaniumplatform.RPMOperating s

NOTE: The AMD64 is an AMD Opteron processor.The EM64T is an Intel Xeon processor with Extended Memory 64 Technology.The x86 is an Intel Pentium III/IV

16

3 Initial setupYou can install HP System Management Homepage (HP SMH) on systems running HP-UX,Linux, and Windows.Additionally, you can install HP SMH

18

4 Installing on HP-UXThis chapter provides steps to install HP System Management Homepage (HP SMH) on theHP-UX Operating Environments (OEs):• “System

© Copyright 2004 - 2007 Hewlett-Packard Development Company, L.P.Legal NoticesConfidential computer software. Valid license from HP required for posse

Installation requirementsTo install HP SMH, your system must meet the minimum requirements. The following listprovides a general review of requirement

ReleaseStatusPathBundleProductHP-UX 11i v1, v2, v3Recommended:Certain HP SMHplugins, such asProperty Pages foundon the Home pagerequire it./usr/lib/sw

install on multiple systems. See the Ignite-UX Administration Guide and the Software DistributorAdministration Guide on the HP Technical Documentation

7. Use the swinstall command to install the product to your system:swinstall -s /var/temp/ depot_filename.depot bundlenameFor example: swinstall -s \/

ScriptDescriptionVariable/opt/hpsmh/conf/timeout.confThe TIMEOUT_SMH environmentvariable defines the HP SMH servertimeout in minutes. If it is defined

Syntax: smhstartconfig [ -a <on|off> -b <on|off> ] [ -t <on|off> ]Options:-a <on|off> Enable/disable the autostart URL mode.-b

26

5 Installing on WindowsThis chapter provides steps to install HP System Management Homepage (HP SMH) on theWindows operating system.• “Installing HP S

7. Select the level of security you want to provide from one of the following trust modes:a. Trust By Certificatei. Click Next. The Trusted Certificat

Note: The HP SIM server's certificate name cannot contain the following characters:~, !, `, @, #, $, %, ^, &, *, (, ), +, =, ", :, &apos

Table of ContentsAbout this document...5Intende

10. Select IP Restricted Login, and click Next. The IP Address to Include dialog box appears.This dialog box enables you to specify the IP address or

NOTE: Do not copy or import certificates when using the setup.exe /r option.Generating a setup.iss fileTo generate your own setup.iss, run the followi

Configuring HP SMHThe HP SMH configuration is based on environment variables and tags that are set by the%SystemDrive%\hp\hpsmh\conf\smhpd.xml, file.

6 Installing HP SMH using the ProLiant Remote DeploymentUtilityThis chapter provides steps to install HP System Management Homepage (HP SMH) on theWin

Installing remotely on Windows using ProLiant Remote Deployment UtilityTo preconfigure the HP SMH component:1. Under All configurable components, righ

7. Select the level of security you want to provide from one of the following trust modes:a. Trust By Certificatei. Select Trust By Certificate.ii. Cl

ii. Click Next. The IP Binding dialog box appears.Note: The Trust All option leaves your system vulnerable to security attacks andsets up HP SMH to ac

7 Installing HP SMH using the HP Smart-Update Manager(HPSUM)This chapter provides steps to install HP System Management Homepage (HP SMH) on theWindow

Installing HP SMH remotely on Windows using HP Smart-Update Manager(HPSUM)1. To start the deployment, run HPSUM.EXE. The Inventory Progress screen is

2. In the Group Name field, enter the name of an operating system group that you want toassign (for example, vcadmin).3. In the Operating Level field,

6 Installing HP SMH using the ProLiant Remote Deployment Utility...33Installing remotely on Windows using ProLiant Remote Depl

software to the wrong system. This option verifies only the HP SIM server's certificatename submitted.NOTE: HP strongly recommends using the Trus

10. The IP Restricted Login enables the HP System Management Homepage to restrict loginaccess based on the IP address of a system.You can set address

42

8 Installing in-place on LinuxThis chapter provides steps to install HP System Management Homepage (HP SMH) in-placeon Linux x86 systems and x86_64 sy

To configure HP SMH settings:1. Enter the following command to start the configuration:perl /opt/hp/hpsmh/hpSMHSetup.plEnter the following command to

4. Configure Local and Anonymous Access. The following options are available:• Enter 1 to enable Anonymous Access.Caution: HP does not recommend the u

a. Trust by Certificatei. To add a certificate file:A. Enter 1. You are prompted for the certificate location.B. Enter the file path of the trusted ce

c. Trust Alli. Enter 3 to Trust All. Trust Mode: Trust All appears.ii. Enter n for next. The IP Binding screen appears.d. Modify Certificate ListEnter

9. Configure HP SMH to restrict login access based on the IP address of the system from whichthe login is attempted.The following options are availabl

10. Enter n to go to the next screen. The configuration completes, and a message appearsindicating that HP SMH is successfully set up. The HP SMH serv

About this documentIntended audienceThe HP System Management Homepage (HP SMH) is a web-based interface that consolidatesand simplifies single system

50

9 Installing directly on LinuxInstalling in-place on Linux ItaniumThis chapter provides steps to install HP System Management Homepage (HP SMH) in-pla

3. The Operating System Groups screen enables you to add operating system groups to HPSMH.Add or delete operating system groups in HP SMH. The followi

5. Enter n to go to the next screen or enter p to go to the previous screen.6. Enter n to go to the next screen. The Trust Mode screen appears.7. Conf

b. Trust by Namei. Enter 2 to Trust by Name.The line with 2 Trust by Certificate (selected) becomes yellow.ii. Enter 4 to Modify Server Name list.To

9. Configure HP SMH to restrict login access based on the IP address of the system from whichthe login is attempted.The following options are availabl

10. Enter n to go to the next screen. The configuration completes, and a message appearsindicating that HP SMH is successfully set up. The HP SMH serv

10 Installing in-place on Linux using Linux Deployment UtilityThis chapter provides steps to install HP System Management Homepage (HP SMH) in-placeon

6. In the Please enter the Operating System (OS) Group Names for user-level access.(Max five names, separated by semicolon or space) field, enter the

Installing HP SMH without preconfigurationYou can install the HP SMH component without any configurations by clicking Install. You canconfigure HP SMH

Chapter 12 “Logging in and logging out of HP SMH” (page 63)Chapter 13 “Uninstalling HP SMH” (page 67)Related informationThis section lists the HP SMH

60

11 Initializing the software for the first timeAfter HP System Management Homepage (HP SMH) has been installed and configured for thefirst time, a pro

62

12 Logging in and logging out of HP SMHThis chapter provides browser and command line instructions for logging in to and out of HPSystem Management Ho

1. Navigate to https://hostname:2381/.To avoid an active scripting error, HP recommends that you add the HP SMH URL to InternetExplorer's Trusted

Logging in with Mozilla and FirefoxTo log in to HP SMH with Mozilla and Firefox:1. Navigate to https://hostname:2381/.If you are using Mozilla or Fire

• In the System Management Homepage banner, for HP-UX click Sign Out and for Linux andWindows click logout.• Close every instance of the web browser t

13 Uninstalling HP SMHThis chapter provides instructions on how to uninstall HP System Management Homepage (HPSMH) from HP-UX, Linux, and Windows syst

Uninstalling manually for Windows and Linux systemsUninstalling manually duplicates the actions of the HP SMH uninstaller, which can be accessedthroug

Uninstalling manually for HP-UX systemsThis section describes how to manually uninstall HP SMH on an HP-UX system.CAUTION: Manually uninstalling HP-UX

home at http://www.hp.com/go/softwaredepot and search for System ManagementHomepage.• HP ProLiant Essentials software page This web page is at http://

70

IndexAaudience, 5Cconsole installLinux, 43console InstallationLinux system preparation, 51Ddocument organization, 5documentation, 6Ffeaturesnew, 5Gget

setup, 17software, 15, 61Ttypographic conventions, 5Uuninstalling, 67Wweb browsers, supported, 12web sites, 15Windowsinstall, 27install HP Smart-Updat

Publication DateEdition NumberSupported VersionsSupported OperatingSystemsManufacturing PartNumberJune 20064For HP-UX: HP-UX11i v2 (B.11.23),HP-UX 11i

1 Product overviewThe HP System Management Homepage (HP SMH) is a web-based interface that consolidatesand simplifies single system management for HP