Red Hat ENTERPRISE LINUX WS 2.1 - Installationsanleitung PDF herunterladen (Seite 28)

d) In the appearing window: Check the required system → Click Next

e) In the appearing dialog box: Select the spectrometer configuration name →

Click Next

f) In the appearing dialog box: Check the items you want to install or, accept

the default selection → Click Next

g) In the appearing dialog box: Select the default printer and plotter and the

desired paper format → Click Next

h) In the appearing window: Enter the desired spectrometer frequency, acquisi-

tion mode and pre-scan-delay or, accept the default values → Click Next

i) In the appearing information box: Check the configuration selection and, if

it is correct → Click Finish

and wait ...

• Continue with edsolv

Check the list of lock solvents → click Save if it is correct → Click Close

• Continue with edhead

Select the current probe → click Define as current probe → Click Exit

A window Edit Spectrometer Parameter will appear:

Check if the connections between preamplifier and probe are set correctly →

click Save if it is correct → Click Close

• Continue with edprosol

Check the parameters for your observed nuclei, and if necessary change

and/or recalculate them → Click Save to store to disk → Click Exit

• Continue with edlock

Check the lock table values (field, lock phase, ...), change them and click

Save if necessary, otherwise click Abort

• Continue with edscon

Check the spectrometer constants, change them and click Save if necessary,

otherwise click Cancel

• After finishing the configuration a window

cron check appears. Click on

Automatic backup to set up an periodically backup of your TOPSPIN

spectrometer configuration.

If you click OK in the following window an automatic backup every 4 weeks

will be initiated.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 271 272

Keine Kommentare

Red Hat ENTERPRISE LINUX WS 2.1 - Installationsanleitung Seite 28