Red Hat NETWORK PROXY 5.3.0 - Bedienungsanleitung PDF herunterladen (Seite 14)

Installation on Linux

and group. In each case, to accept the default value (recommended),

and press “Enter”.

where should webwasher be installed? (/opt/webwasher-csm)

which user s hould webwasher run as? (wwasher)

which group should webwasher run as? (wwasher)

The installation is now complete, and the ICAP server is running.

6. Now Webwasher should be installed and running, and waits for requests.

For an easy, alternate method of installing on Debian, SUSE, and Red

Hat, please refer to Sections 4.1, 4.2 and 4.3 accordingly.

4.1

Alternative Installation on Debian

When installing Webwasher on Debian, the following issue must be dealt with.

It was found under Debian 3.0, but could also occur with other distributions of

Linux.

Webwasher will not run i f in the Linux kernel the capability module has not

been loaded and at the same time the CONFIG_SECURITY=Y flag is set.

To solve this problem:

• Load the capability module by configuring:

modprob capability

or:

• Set the flag mentioned above to a negative value:

CONFIG_SECURITY=N

To perform the installation procedure, complete the following steps:

1. Download your .deb package, e.g.

webwasher-csm-5.3.0-995-debian-3.1-intel.deb

2. Install it via

dpkg --install <DEBIAN PACKAGE>.deb

Webwasher will be installed in /opt/webwasher-csm.

4–2

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Keine Kommentare

Red Hat NETWORK PROXY 5.3.0 - Bedienungsanleitung Seite 14