Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Installationshandbuch PDF herunterladen (Seite 56)

36 z/VM and Linux on IBM System z: The Virtualization Cookbook for Red Hat Enterprise Linux 6.0

3. Invoke the instplan command. This will allow you to choose associated z/VM products to

install, the language to use, and the type of DASD on which to install (Figure 4-9):

==> instplan

Figure 4-9 Installation planning panel

4. You may need to clear the window with the Esc key. You should then see the display as

shown in Figure 4-9. It is recommended that you leave the Ms in the top section alone.

5. Type the letter x next to AMENG (or select your language) and 3390 Mod 3 (or the type of

DASD you will use), as shown in Figure 4-9. You can use the Tab key to move to the next

input field.

6. Press F5. You should see the message HCPINP8392I INSTPLAN EXEC ENDED SUCCESSFULLY

after a list of what will be installed.

7. Attach the DASD devices onto which z/VM will be installed defined in your planning

worksheet in 2.7.2, “z/VM DASD worksheet” on page 17. In this example, the devices are

6280-6284.

==> att 6280-6284 *

6280-6284 ATTACHED TO MAINT

Important: The devices 6280-6284 are in bold italics to signify that you should replace the

example value with the correct value for your site. For example, if you are installing z/VM

onto DASD 1200-1204, you would type the following:

==> att 1200-1204 *

This convention is used throughout the book.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 295 296

Keine Kommentare

Red Hat LINUX VIRTUAL SERVER 4.6 - ADMINISTRATION Installationshandbuch Seite 56